A brief introduction about VapeOnly VPIPE II Bottom

VapeOnly VPIPE II Bottom Coil Changeable System 18350 e-pipe Starter Kit is a new creative e-pipe, with a changeable coil. The front-end of VPIPE II adds LED lights and the dedicated battery is removable and rechargeable 3.7v 900mAh 18350 lithium battery. Refillable atomizer with a changeable coil, BCC coil unit holds about 1ml e-juice. Included: 1pc VapeOnly VPIPE II body 1pc VapeOnly VPIPE II atomizer 1pc 1.8ohm is installed, 1pc 2.2ohm is in the box VapeOnly VPIPE II coil unit 2 pcs 3.7V 18350 900mAh rechargeable Li-Ion Battery 2 pcs VapeOnly AC charger 1 pc Power cable Parameter Length (with mouthpiece) 160mm Diameter 52mm How to assemble VapeOnly VPIPE II? 1. Unscrew the battery cap 2. Insert a fully charged battery positive side up 3. Screw down the battery cap 4. Pull the mouthpiece out 5. Insert a VPIPE II atomizer with e-liquid (easy to fill with e-liquid) 6. Insert the mouthpiece, DONE! Function: Battery Setting Indication: The red LED light flashes 3 times. Work Indication: The red LED light. Constant voltage output: 3.3v Short circuit protection: If a short circuit happens to output end, LED will flash 3 times, which means that the device has no voltage output. Atomizer Protection: If vapor for more than 10 seconds, the voltage will be cut down automatically, meanwhile, the LED will flash 10 times. Low Voltage Protection: When the voltage is lower than 3.3v,the red LED will flash 10 times, then it enters low voltage mode and stop vaporing. Battery inversion protection: When the battery is set incorrectly, pipe will not work. Mayne you want get the: VapeOnly vPipe 3 e-Pipe 18350 Starter Kit