Vapefly Brunhilde from BuyBest

I ordered the new evaporator from Vapefly Brunhilde at BuyBest and paid directly via Paypal. When ordering it was pointed out that it is a Presale and with the delivery on 16.03.2019 is to be expected - to wait. In my account - under 'notifications' I was once again advised that the vaporizer will be delivered immediately upon receipt. The evaporator arrived at the end of March. The vaporizer is an original product and will be delivered in its original packaging. The scope of delivery was complete, as stated in the product description. As I have learned from the many videos on the evaporator, the supplied coils should not be too good. But I still used them to make my own picture of these coils. Unfortunately, all the reviewers were right, and the coils supplied went to the garbage after a day. Since I did not want to change completely - from my point of view very expensive - prefabricated coils, I then turned a wire from the company Coilology (tricore fused Clapton 26/36) 2 coils with ID 3.5mm / 7 turns and installed them. Hereby the evaporator works perfectly. Taste and amount of steam are now more than enough available. I steam the coils now with 75 watts with almost completely open side airflow and fully opened 3D Airflow. When installing the coils, I was guided by some videos that have used the feet of the coils contrary to the actual procedure. So the lower foot into the upper hole and the upper foot of the coil in the lower Bestfestigungsloch. I first press the coil firmly against the posts - screw the coil - and then pull it first forward / down. Problems with the filling - due to the limited filling hole - I have none because I own PET bottles use a relatively thin tip. The included drip tip I personally find very successful. Due to the height of the drip tip, it is possible to steam without touching the lips with the top cap. Depending on which winding you installed, the top end of the top cap can be quite hot. The diameter of the Drip-tip I feel as optimal - is very pleasant in the 'mouth'. The O-rings on my Brunnhilde for the top-cap and the drip-tip are sufficiently dimensioned and keep everything in its place - as it should be. The finish of my vaporizer is also worked without hesitation. Nachflussproblemen I have gone out of the way, that I have equal to cut my own steel wicks from a hardware store rope itself. I did not install the originally enclosed wicks so I can not say if they would not work without problems. If there is anything to complain about the Brunnhilde, then in my view, that is not quite thought-out Airflow. If you want to reduce the 3D-Airflow, you adjust the TOP-Cap and then the Side-Airflow is no longer in the middle of the coils. Here one might have to design the top cap in two parts so that the two airflows can be regulated separately. This would have nat. As a result, the lettering could not have been attached. The Airflow itself is very smooth and not too loud for my feeling. I could not find any turbulence. The liquid capacity of 8ml is a fine thing, as the Brunhilde then quite neat 'drinks'. Maybe there will be a 'short' version at some point, as other manufacturers have already demonstrated. Personally, I'm fine with the size of the vaporizer. Conclusion: for steamers like the Topcoiler, the Brunnhilde is a relatively cheap alternative to the proven Topcoilern (Corona V8, VG Extreme, etc.) Also, this Topcoiler is the dimensions of a neatly large piece of metal. There are in my opinion a lot of RTA's on the market, which builds far smaller, produce just as good taste and quantity of steam and then cheaper to buy. But if you just want to try a Topcoiler, for the Brunhilde is due to the relatively low price (compared to the other original Topcoiler) a very good option.